hasemepic.blogg.se

1. SYMANTEC ENDPOINT MANAGER STOP BACKUP HOW TO
2. SYMANTEC ENDPOINT MANAGER STOP BACKUP INSTALL
3. SYMANTEC ENDPOINT MANAGER STOP BACKUP UPGRADE

Click Start > Programs > Symantec Endpoint Protection Manager > Database Back Up and Restore.The overinstall process saves legacy settings, and then upgrades to the latest version.

SYMANTEC ENDPOINT MANAGER STOP BACKUP INSTALL

You do not need to uninstall previous clients before you install the new version.

SYMANTEC ENDPOINT MANAGER STOP BACKUP UPGRADE

Upgrade the Symantec Endpoint Protection ManagerĪfter you migrate all servers that used replication including the servers that were configured for failover and load balancing, you need to re-enable replication.WARNING: You must stop the Symantec Endpoint Protection Manager service before you perform this procedure or you will corrupt your existing installation of Symantec Endpoint Protection Manager. After you upgrade, the service is started automatically. Stop the Symantec Endpoint Protection Manager serviceīefore you upgrade, you must manually stop the Symantec Endpoint Protection Manager service on every management server in your site.You must disable replication at each site that replicates. If your site uses replication, you must disable replication before upgrading Symantec Endpoint Protection Manager. Symantec strongly recommends that you migrate the entire network to the current version rather than managing multiple versions of Symantec Endpoint Protection.īefore you upgrade, you should back up the database. Migration to the current version of Symantec Endpoint Protection includes the following steps in order:īefore you begin to install the Symantec Endpoint client, manager, and any administration upgrades, you should have a solid understanding of your network topology and a streamlined plan to maximize the protection of the resources on your network during the upgrade. You do not need to uninstall existing clients before you install the new version. When you migrate a client, the overinstall automatically detects the client, and migrates and installs it appropriately. You do not need to uninstall management servers before you install the new version. When you migrate a server, the installation automatically detects and configures it appropriately. The following table gives an overview of the migration process for each component of Symantec Endpoint Protection: The installer package to upgrade Symantec Endpoint Protection is available from the Symantec Fileconnect site.Symantec Endpoint Protection 11.0 (RTM), (MR1), (MR1 MP1), (MR2), (MR2 MP1), (MR2 MP2), and (MR3).ĭownloading the Symantec Endpoint Protection MR4 Maintenance Release.Symantec Endpoint Protection (MR4) can migrate seamlessly over the following: This section lists the platforms that are supported during migration to the current version of Symantec Endpoint Protection. If your site uses replication, you must disable replication before upgrading Symantec Endpoint Protection Manager.Please read "Best Practices for Disaster Recovery with Symantec Endpoint Protection" at: Before you upgrade, you should back up the database.The following is a list of critical information that you need to know in order for your migration to succeed. Things to know to ensure a successful migration If no previous versions of Symantec Endpoint Protection products are already installed, please read the installation guide. This document is meant only for migrations in which a previous version of Symantec Endpoint Protection 11.0 exists on the network or on individual computers. This information includes supported migration paths and factors that can affect the success of the migration. This section gives the information that you need to know in order to plan for migration.

SYMANTEC ENDPOINT MANAGER STOP BACKUP HOW TO

This document describes how to migrate to Symantec Endpoint Protection 11.0 Maintenance Release 4 (MR4). Migrating to Symantec Endpoint Protection 11.0 MR4